In kashar cheese production vats, product adhesion to the walls may appear as buildup during scalding or kneading and as difficulty cleaning. A PTFE coating request should clearly identify the vat’s function. Coagulation vats, scalding tanks, and kneading equipment do not operate under the same process conditions.
Distinguish product residue from mineral buildup
Cheese curd mass or protein residue is not the same problem as the mineral buildup known as milkstone. Do not select a nonstick surface on the assumption that it eliminates every type of deposit. Record where the problem occurs, its appearance after cleaning, and the production stage in which it develops.
Contact between the surface and an agitator, paddle, or scraper matters in coating selection. Mechanical friction is a load that must be evaluated for the system. Internal corners, weld areas, and outlet connections are separate inspection areas. Coating does not automatically correct poor joint geometry or damaged metal.
CIP compatibility depends on conditions
For a clean-in-place system, or CIP, report the chemicals used, temperature, duration, and cleaning sequence. The PTFE name does not establish suitability for every CIP program. Assess compatibility of the system, including primer and topcoat, with these conditions. Do not reduce the cleaning procedure simply because a new surface has been applied.
- Vat function, base metal, and drawing
- Product, salt, or acid contact
- Process temperature and operating duration
- Agitator or scraper contact points
- CIP or manual cleaning conditions
Acceptance criteria for the application
During technical assessment with Powerpan, evaluate food-contact suitability for the actual use. A general FDA or ISO statement does not show that a coated vat is suitable for every cheese process. Before quotation, also confirm that the area to be coated is compatible with the application equipment and process conditions.
During the trial, monitor product release, residue location, and surface integrity after cleaning. If heat transfer is an expected outcome, make it a separate assessment point from the coating’s release function. Do not assume coating automatically improves heating or kneading performance.
Remove a surface showing cracks, blistering, or separation from the relevant service for quality assessment. Evaluate chemical effects, mechanical contact, and base metal condition together before renewal. Maintenance history helps explain recurring damage.
Not all areas inside the vat experience the same loads. Record the product-level region, outlet, and surfaces near the agitator separately. A clean, easily visible upper area is not a sufficient assessment. The trial should also cover the area causing the most difficulty in use and its condition after cleaning.
