Product sticking to a worn tray and a tray failing to seat correctly on a rack are different problems. The first may involve the surface; the second may involve the body or edge geometry. When preparing a tray repair request, do not present recoating and mechanical work as the same operation.

Inspect the base and edges

Record base waviness, crushed edges, and opened joints separately. Deformation across a large surface can affect product placement and handling. Coating is considered as a way to provide a new contact surface; it is not a guarantee of straightening bent sheet metal or strengthening a weakened body.

On perforated trays, also inspect blocked openings, residue buildup, and damage at perforation edges. For gastronorm pans, inspect deep internal corners and the upper rim. Assess existing dimensions together with rack or lid compatibility. Do not assume every tray can undergo the same preparation method.

Decisions on surface damage

Reduced release performance, scratching, coating blistering, and exposed metal represent different levels of damage. If peeling occurs, remove the tray from use for quality inspection. Scraping the old layer in place or applying coating indiscriminately over damage is not professional recoating.

ObservationAssessment
Sticking on the baseResidue, formulation, and surface wear
Poor rack fitEdge and body dimensions
Rust or cracksMetal integrity and suitability for use

What information should a request include?

Send Powerpan the tray dimensions, metal type, quantity, and damage photographs. The oven used, product group, cleaning chemical, and daily handling arrangement also inform the assessment. If mechanical repair is needed, confirm its feasibility separately.

After delivery, check rack seating, stacking, and surface integrity. A trial with the actual product is necessary to assess coating function. A new appearance is not evidence of original performance; acceptance criteria should be set during quotation.

Clean recoated trays according to the instructions and use a stacking arrangement that avoids rubbing the surface. Repeated damage at the same point calls for a review of handling or maintenance methods. The decision between recoating and replacement depends on metal condition and the overall scope of work.

A repair request can include both a close-up of the edge and an overall view of the tray. The close-up helps show the surface defect; the overall view helps explain shape and handling arrangements. Dimensions must be supplied separately; a photograph alone is not technical evidence of rack or lid compatibility.

Contact us for a project quotation

Tell us about your baking equipment or recoating requirements, including dimensions, quantities and operating conditions.