Quality assurance system

Quality assurance requires a broader approach than looking only at a coating’s appearance at delivery. Material selection, surface preparation, application, and the scope of use should be defined from the outset. In a coating project for Powerpan, it is important that these decisions and the inspection results are consistent with one another.
While quality control assesses a result at a particular stage, an assurance approach also addresses the conditions under which the work will be performed. No method, however, means that all defects are unconditionally prevented. What matters is that the inspection scope is appropriate to the part and the system.
From requirements to application
The part material, geometry, and operating conditions are matched to the selected system. Areas to be coated and surfaces to be protected are identified. During refurbishment, a decision to replace the old layer with a new coating should not be made before the body’s suitability has been examined.
Process parameters must be based on the relevant technical information. The same preparation or curing specification may not apply to every part. Application changes and sample requirements are assessed separately. Acceptance criteria are defined at the start of the project, not after the results are seen.
Traceability and measurement
The part or batch identity, applied system, and inspection records should be capable of being linked. The measurement method should suit the surface and base material. The suitability of the device, the measurement area, and interpretation of results are considered together.
- Technical requirement and acceptance criterion.
- Application scope and material information.
- Inspection points and record requirements.
- Segregation and assessment in the event of a nonconformity.
Food-contact documents and corporate certificates provide different information. A management system certificate does not mean that every product is suitable for every use. The existing scope of a requested report or inspection should be confirmed during quotation discussions.
When a nonconforming part is identified, the affected group should be segregated and the cause investigated. After correction, compliance with the same criterion is checked. Problems arising during customer use are also assessed together with the equipment identity and conditions. Quality assurance becomes clearer through connected decisions supported by records, rather than a general promise of defect-free work.
