When assessing a technical problem with coated equipment, consider both the product’s identity and its operating conditions. These answers provide general guidance; the instructions for the applied system and a part-specific assessment take precedence. You can submit your technical inquiry by calling +90 212 886 25 67.

Temperature and system selection

Is there a single temperature limit for PTFE coatings?

Check the technical information for the product and system used. Chemours’ product table lists use temperature and curing temperature separately. A product’s processing temperature must not be interpreted as an authorized operating temperature for the finished part.

Is choosing a name associated with higher temperatures enough to replace the current coating?

No. The substrate, contact time, product, and other operating conditions must be assessed. A trade name alone is not a basis for selection. Discuss the relevant technical file and intended scope of use.

Cleaning and surface preparation

Which cleaner should I use?

Follow the instructions provided for the coating and equipment. The product name, concentration, temperature, and contact time must be considered together. There is no single pH range or cleaning procedure that applies to every coating.

Is every part abrasive-blasted in the same way?

Surface preparation depends on the substrate and system. Do not copy abrasive media, pressure, or process sequences from a general article. How the existing surface should be prepared must be established through application-specific instructions.

Can I use a fixed cooling time?

No single time can be specified without knowing the part, process, and instructions for use. Avoid practices that expose hot equipment to sudden temperature changes, and follow the applicable cooling instructions.

Damage and documentation assessment

Can I continue using a peeling coating?

Remove the equipment concerned from service and notify the facility’s quality manager. Products that have been in contact with it, and the equipment’s return to use, must be assessed under facility procedures. A phone inquiry or photograph alone does not constitute approval for use.

Does ISO 22000 certification show that a coating is suitable for every food?

No. ISO 22000 is a food safety management system standard. Documents relating to the product and operating conditions must be assessed separately to determine the suitability of a particular part.

What information should I send for technical review?

Share the part description, application date, symptoms, photographs, and recent changes. Describe operating conditions fully; do not estimate an unknown value and present it as confirmed information.

Contact us for a project quotation

Tell us about your baking equipment or recoating requirements, including dimensions, quantities and operating conditions.