Material buildup on a screw conveyor’s shaft or flights can affect cleaning needs and conveying behavior. A nonstick coating may be assessed for these contact surfaces. Blockage, wear, and low feed rate are different problems, however; coating is not a certain solution to all of them or a guarantee of increased capacity.
Detail the spiral geometry
Both faces of the screw flight, its outer edge, and the flight-to-shaft junction are separate inspection areas. Application must account for access to these surfaces and coating distribution. Narrow gaps or welded areas may need different preparation from a flat plate.
The working clearance between the flight and housing matters for dimensions after coating. If the base metal is bent, flights are worn, or welds are damaged, assess the mechanical condition first. Coating should not be presented as a repair method that restores lost flight dimensions.
Conveyed product and operating arrangement
Include the characteristics of the powder, granules, or sticky product in the request. Moisture, particle characteristics, process temperature, and abrasiveness create different surface requirements. Expectations may also differ for horizontal, inclined, or metering applications. Easy release from a surface does not automatically deliver the required feeding accuracy.
- Screw drawing, base metal, and dimensions
- Shaft and flight areas to be coated
- Housing clearance and mounting areas
- Conveyed product and operating conditions
- Cleaning method and existing wear
Monitor surface and conveying behavior together
Assessment with Powerpan should explain the selected system’s mechanical and chemical operating limits. A low-friction description alone is insufficient, especially with abrasive materials. For equipment conveying food, assess product-contact suitability separately.
Run the trial with the actual material and monitor buildup, discharge behavior, and coating integrity. If screw speed or feeding conditions change, do not compare results directly with the previous trial. After cleaning, inspect hard-to-reach areas of the spiral surface as well.
Flights rubbing against the metal housing or aggressive scraping can damage the surface. If peeling occurs, remove the equipment from use for quality inspection. Before recoating, investigate whether the damage resulted from buildup, wear, or incorrect clearance.
Buildup may differ at the screw’s inlet and outlet. Recording these areas separately makes the surface requirement more specific. When assessing a new application, inspect the other product-contact face as well as the flight visible from outside. Hard-to-reach areas should not be excluded from inspection.
