Coating a screw conveyor component

Screw conveyor coating should be evaluated against the material being conveyed, the component geometry and the mechanical contacts in service. The screw, trough and adjacent surfaces may have different duties. A surface treatment does not correct an unsuitable clearance or damaged flight geometry.

Provide a component and exposure brief

Identify the substrate, dimensions and areas to be treated. Describe the conveyed material, operating temperature, cleaning method and any abrasion or repeated contact. Mark bearing, fastening and mating surfaces that must remain within specification.

Photographs should show wear, deposits, corrosion and repaired areas. Used components need a structural and dimensional assessment before stripping or recoating is considered.

Agree the function and validation

State whether the intended coating function concerns release, residue or another defined requirement. Confirm the proposed system’s operating limits and relevant documentation, including food contact where applicable. A coating’s suitability for one conveyed product does not establish suitability for another.

Define the finished-component inspection and a representative operating trial where needed. Include drawings, quantities and assembly requirements with the enquiry. Avoid treating a general non-stick claim as evidence of unrestricted abrasion resistance or a fixed increase in conveying performance.

Contact us for a project quotation

Tell us about your baking equipment or recoating requirements, including dimensions, quantities and operating conditions.